Hello CC,
To do this you need..
Xbox one chat headset
One RCA Red/White Cable
3.5mm Jack to RCA
6.35 Jack to 3.5mm adapter
One receiver with a Optical Audio input
Another receiver or small audio device with 2 inputs that can overlap one another
Soldering iron
Solder
Electrical Tape
Optical Wire
Take your optical wire and hook it to the back of the xbox.
Same thing to receiver
Go into settings Display/Sound, Audio Output, Select Optical Audio
Go into settings Display/Sound, Volume, Party Chat Output, Headset
Hook the 6.35 Jack to the 3.5mm Jack RCA cable
Plug The left and right into the correct colors
Now the fun begins...
Cut the RCA RED cord in half.
Cut the RCA WHITE cord in half.
Slice them open and Wrap the ground together.
Same thing with the xbox head set cut the chat piece off where the headset meets the Mic/Speaker
Do the same thing with the Red/White cord, then wrap grounds to grounds
Slice the wires open and Wrap the ground with the other ground
Be careful with the BLUE and GREEN wires on the xbox chat cord.
NOW FOLLOW THE NUMBERS IN THE PICTURE BELOW!!
1,4,8,9 SOLDER TOGETHER
2,6 SOLDER TOGETHER
7,3 SOLDER TOGETHER
5,10 SOLDER TOGETHER
Now tape the wires up.
Your product should look something like this:
Now once you plug in your chat pad, The receiver that has the 2 inputs in the back of it controls the volume All together. The receiver with the optical audio controls game volume
LOL AT MY ROCKBAND MIC!
Well good luck!
Posted by RealCFW.